Logitech G Flight Yoke System Guide De L'utilisateur page 9

CONFIGURING YOUR FLIGHT YOKE AND THROTTLE QUADRANT FOR
MICROSOFT FLIGHT SIMULATOR 9 AND FSX
The Flight Yoke System's buttons, controls and axes correspond to commonly used
functions in Microsoft FS9 and FSX. As with any software, if you wish to change
the function of a button or control, you will need to change the settings of the game
software.
Once you have done this, simply find the command that you want to assign to
your controller from the list of commands, click it and then click the Change
Assignment button. A window will appear asking you to move the part of your
controller that you want to assign to that command - press/move the button/axis
that you want to assign to that command and then click OK.
Tip: You may find that when you assign the levers on the quadrant to a command,
that they don't appear to work when you test them in the game. If this happens then
you must look in the Sensitivities screen (Flight Simulator 2004) or the Calibration
tab of the Controls screen (Flight Simulator X) of the game, select the axis command
in the list there and ensure that the Sensitivity isn't set too low (set the horizontal
sensitivity slider control to around 70%).
9 English