Designated Use; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Installation - Proficook Universalmixer PC-UM 1195 Mode D'emploi

Designated Use

This appliance is used for:
• Mixing of liquids
• Chopping firm foodstuffs
• Crushing ice
Process hard foods like nuts or chocolate only with fluids.
It is intended for the use in private households and similar
applications.
It is only to be used as instructed in this user manual. The
appliance is not intended for commercial use.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
The manufacturer shall not be liable for damages caused by
not intended use.

Unpacking the Appliance

1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic film, filler
material, cable ties and box packaging.
3. Check that all parts are in the box.
4. If the packaging content should be incomplete or if dam-
ages should be noticeable, do not operate the appliance.
Return it to the distributor immediately.
NOTE:
Dust or production residues may still be found on the
appliance. We recommend that you clean the appliance
as described under "Cleaning".
Overview of the Components /
Scope of Delivery
1 Refill opening cap / measuring cup
2 Mixing jar lid with refill opening
3 Sealing ring for the lid
4 Mixing jar
5 Sealing ring for the knife block
6 Knife block
7 Screw-cap
8 Base section with motor
9 Setting switch (illuminated)
10 Suction base

Installation

Mixing Jar
Place the mixing jar onto the motor housing. The best posi-
tion is when the handle points to the side.
NOTE:
The mixing jar fits onto the motor housing in various
positions.
32
PC-UM1195_IM
Lid
1. Make sure that the sealing ring is attached to the lid.
2. Press the lid firmly onto the mixing jar. It must seal the
mixing jar completely.
3. Insert the cap into the refill opening of the lid. Pay
attention to the guide lugs on the screw-cap. Turn the
screw-cap clockwise as far as it will go.
NOTE:
The refill opening cap can also be used as a measuring
cup.

Notes for Use

CAUTION:
The glass may crack if the temperature is too high! Do
not fill with liquids above 60 °C.
• Place the appliance on a firm and flat surface. Position it
is such that it cannot tip over.
• Only switch on the appliance if the mixing jar is closed
with the lid. The refill opening in the lid must also be
closed.
• Do not overfill the mixing jar! You can fill it to a maximum
of 1.5 litres. Use the scale on the jug.
• Froth requires a large capacity. Reduce quantities of
liquids which produce a lot of froth.
• Keep one hand on the lid if you are crushing ice or if
there is a large quantity of ingredients.
• Cut the food to be mixed into small pieces beforehand.
Electric Connection
1. Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
appliance. You can find the required information on the
nameplate.
2. Connect the appliance only to a correctly installed safety
socket.
Short-Interval Use
The appliance is suitable for short-time operation of max.
2 minutes. Let it cool for 1 minute before using it again!
Pulse Mode
Switch to pulse mode by turning the control to the P posi-
tion and then release it. Use the appliance in this operating
mode for a maximum of 3 minutes. Let it cool for 1 minute
before using it again!
Crushing Ice Cubes
The blades in the mixing jar are also suitable for crushing
ice cubes.
• Put a maximum of 10 pieces (size approx.
25 x 25 x 25 mm) into the mixing jar. Use pulse operation
P for 1 - 3 seconds. Repeat the process 8 - 12 times.
09.09.19