Simplified Eu Declaration Of Conformity - Urmet 1051/104 Guide Rapide

2. Make sure that the tamper switch is open (loosened) by undoing the screw on the bottom.
3. Make sure that the learn function has been activated on the control unit. Within 3 minutes from switch-on, hold the
function button pressed for 10 seconds and then release it when the blue LED and the illuminator blink once.
4. After having been leant by the control unit, the detector is automatically recorded in the system. Check the control unit to
check that the learning and registration procedure were performed correctly.
5. Once learnt by the control unit, if the detector connection is lost, the LED will blink once every 20 minutes to signal the
fault.
Installation
Surface mounting:

1. Loosen the fixing screw and delicately lift the cover to prevent
damaging the tamper switch.
2. Perforate the hole arrangements on the base for fixing on a
surface.
3. Using the two holes as template, make the holes corresponding
to the surface.
4. Insert the anchor bolts if the device is fixed to plaster or bricks.
5. Screw the base into the anchor bolts.
6. Reposition the cover onto the base.
Corner mounting:

1. Loosen the fixing screw and delicately lift the cover to prevent
damaging the tamper switch.
2. Perforate the hole arrangements on the base for fixing in a
corner.
3. Using the two holes as template, make the holes corresponding
to the surface.
4. Insert the anchor bolts if the device is fixed to plaster or bricks.Screw the base into the anchor bolts.
5. Reposition the cover onto the base.
Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR INFRARED DETECTOR WITH CAMERA 1051/104 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.urmet.com.
CLICK ON THE LINK TO ACCESS THE PRODUCT TECHNICAL SHEET AND DOWNLOAD THE
COMPLETE MANUAL
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the
time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health
and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
DS1051-031

SIMPLIFIED EU DECLARATION OF CONFORMITY

Hole arrangement for
fixing on surface (x 2)
Hole arrangements
for corner fixing (x 4)
5