Service And Maintenance; General Information - Festool TOPROCK BT 20 Notice D'utilisation D'origine

6

Service and maintenance

Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.com/service
5
3
2
1
► Clean the machine with a soft, dry cloth to
prevent damage. Do not use solvents.
► Only an authorised service workshop may
replace damaged integrated batteries.
7 Transportation
The Li-ion batteries included are subject to the
requirements of the legislation on hazardous
goods. The user must familiarise themselves
with the local regulations prior to transport.
Special requirements apply to shipping via third
parties (e.g. air transport or haulage) and these
must be observed. When preparing the item to
be sent, a hazardous goods expert must be
consulted. Only dispatch the machine if the
battery is undamaged. Observe local regula­
tions when shipping. Observe any further
national regulations.
8 Environment
Before disposal
Qualified specialist only: Remove the integrated
battery from the machine. To do so, unscrew
the different housing components and remove
the battery.
Do not dispose of the device in the household
waste! Recycle devices, accessories and pack­
aging. Observe applicable national regulations.
EU only: In accordance with EU directives on
waste electrical and electronic equipment and
batteries and accumulators and their imple­
mentation in national law, faulty or used elec­
trical equipment, batteries and battery packs
must be collected separately and recycled in an
environmentally friendly manner.
This machine is labelled with the
symbol for the separate collection
of waste electrical and electronic
equipment (WEEE). This means
that this machine must be recycled or disman­
tled in accordance with European Directive
2012/19/EU to reduce the environmental
impact. Another option is to return this machine
to authorised collection points or a dealer when
purchasing new electrical or electronic equip­
ment.
Used or faulty batteries must only be returned
to collection points if discharged and secured
against short-circuiting (e.g. by insulating the
terminals with adhesive tape). The applicable
regulations must be observed.
Batteries will then be recycled.
Information on REACH: www.festool.com/reach
9

General information

9.1
Information about Bluetooth
The tool can be connected to a mobile device via
Bluetooth . As soon as the tool is connected to
®
the mobile device via Bluetooth
connection has been authorised, the tool will
connect automatically to the mobile device from
this point onwards.
The Bluetooth word mark and the logos are
®
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
9.2 Federal Communications Commission
(FCC) Interference Statement
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer­
ence in a residential installation. This equip­
ment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer­
ence will not occur in a particular installation. If
this equipment does cause harmful interfer­
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
English
®
and the secure
®
11