Control Panel; Cleaning, Care & Maintenance - Buffalo DA564 Mode D'emploi

UK

Control panel

Model: DA565/DA566
Model: DA567
Operation
1. Fill Basket with Hot Dogs,place the basket in the jar and put the lid on the jar.
2. Connect the appliance to the mains power supply.
3. Turn on the ON/OFF switch for the water dish.
4. Set the temperature control knob to desired setting. The appliance begins to heat up.
5. When water is being heated, the indicator light will come on until set temperature is reached, then
indicator light will go out. The power/heating element will come back on when the temperature of
the water drops, the indicator light will come on and heating will continue until the set temperature is
reached again.
6. Remove hot dogs from the jar as required.
7. Bread rolls can be warmed on the pins. Carefully push the roll down on to the pin then turn on the
corresponding ON/OFF switch to warm.
Thermal Protection Reset Button
• This appliance is fitted with thermal protection device to protect the unit from damage due to
overheating, low water etc. The RESET BUTTON is located on the rear of the unit.
• If unit overheats, allow to cool then reset by removing the cover and pressing the button.
Cleaning, Care & Maintenance
• Before cleaning takes place, the Warmer should be disconnected from the
electricity supply by removing the plug from the socket.
• Do not attempt to clean the warmer or parts until they have completely
cooled.
• Water Dish, Glass Jar and Lid should be washed in soapy water, then thoroughly rinsed after every
session of use.
• Other areas of the Warmer should be wiped down with a clean, damp cloth, or using a food safe
antibacterial cleaner.
4
DA564-DA567_ML_A5_v3_20210521.indb 4 DA564-DA567_ML_A5_v3_20210521.indb 4
ON/OFF switch
for pins
ON/OFF switch
Indicator
light for water dish
Temperature
control knob
2021/5/21 15:47 2021/5/21 15:47