Installation Instructions - Truma ZUE Mode D'emploi

Installation instructions

During works the
current supply of the
heater must be disconnected.
It is not enough to switch the
heater off at the control panel.
Connecting under power can
destroy the time-switch and the
heater-electronics!
In commercial vehicles which
transport dangerous goods
according (GGVS / ADR) the
use of a time-switch is not
permitted.
The timer switch is to be in-
stalled in the commercial vehicle
format (part no. 39890-00),
either in the apertures provided
for in the dashboard (page 4;
fig. A) or with an installation
frame (fig. B) at a suitable
location.
14
In the camping design format
(part no. 39891-00, 34042-
01 or 34043-01 respectively),
installation is effected with an
installation frame (fig. C), for
preference in the living area.
1. Locate a convenient place
with a fitting depth of at least
45 mm.
If the time switch cannot
be flush-mounted, Truma
can provide an on-surface frame
(fig. D, part no. 39050-11600)
as an accessory.
2. If required, cut out the instal-
lation template (page 3) corre-
sponding to the installation type
provided for (B or C), and glue
it above the intended installation
location. Make the preliminary
perforation of the centre hole
and cut out the installation
aperture.
3. Depending on the type of
installation planned, screw the
installation frame (B) in place, or
secure the installation frame (C)
to the timer switch with the
clamps provided.
4. Plug the cable in at the clock,
guide it through the installation
aperture, and lay it to the elec-
tronic control unit of the heating
system.
5. Push the pre-fitted timer
switch into the installation aper-
ture until it engages (A and B),
or screw on the installation
frame (C).
6. Unscrew the cover of the elec-
tronic control unit and expose
the cable passage. Insert the
plug into the accessory pin strip.