Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
MAINS VOLTAGE
Before plugging in, check that the mains voltage corresponds to the voltage indicated on the technical data sticker of the machine. Pls. check the notes
and instructions concerning electrical connection.
WARNINGS: CAUTIONS TO BE TAKEN AND SAFETY RULES
When using electrical appliances, basic safety precautions should always be followed including the following:
-
Read all instructions.
-
Do not operate any appliance with a damaged cord or plug or after the appliance malfuction, or is dropped or damaged in any manner.
Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.
-
The use of attachments not recommended or sold by the manifacturer may cause fire, electric shock or injury.
-
Do not use outdoors.
-
Do not use in wet places or wet support
-
Do not submerge the item in water or other liquid when cleaning
-
Do not use extension cables
-
Do not unplug by pulling the cable
-
Do not use the machine with wet hands or bare feet
-
Do not let cord hang over edge of table or counter.
-
Acoustic level less than 90 dBA.
-
Save these Instructions
-
Be careful during machine operation as heating elements are present on the welding bar (7.).
-
Only use embossed bags for food preservation in vacuum conditions, of the same type as those supplied with the unit.
-
Do not plunge the unit into water and do not us it if the plug or plug cable are wet to avoid risks of fire or electric shock.
-
Do not overfill the bags to avoid risks to damage the aspiration circuit or to short-circuit the vacuum pump.
-
Carry out any operations on the unit (cleaning included) with plug cable disconnected from the socket to avoid risks of electric shock.
-
Vacuum packaging does not replace other preservation methods but it can be combined with them.
-
Perishable food requires cooling or freezing to prevent deterioration. Vacuum packaging prolongs preservation times and helps the
organoleptic qualities to be kept unaltered.
-
In any case pre-packaged products shall be used within the date indicated on packing.
-
A higher vacuum level corresponds to a lower oxygen quantity with resulting possibilities of better preservation.
-
Liquids shall be refrigerated before vacuum-packaging in bags to prevent them from leaking out and being sucked into the vacuum
chamber.
-
Clean the vacuum chamber in case of aspiration of liquid or powder with normal cleaner for plastic material, be careful to let the vacuum
chamber dry after cleaning.
-
" Only for U.S.A. use" To reduce risks of electric shock, this product has a polarized plug ( one blade is wider than the other). This plug is
intended to fit in a polarized outlet only one way. When the plug does not fit fully in the outlet, reverse the plug. When it still does not fit, contact a
qualified electrician to install the proper outlet.
-
Do not change the plug in any way.
-
Close supervision is required when this product is used near children.
-
Products in powder or grains shall be covered with a cloth or protected by a first bag before being vacuum-packaged, so that they are not
sucked into the vacuum chamber and do not obstruct the valve.
-
Containers unsuitable for vacuum packaging can implode through the effect of air pressure and cause damages and injuries. In case of
storage in freezers, only special containers in toughened glass shall be used.
-
The air pump and the welding system are equipped with thermal protection: in case of overheating the unit stops automatically and can
resume work after some minutes.
-
Experience and practice will enable you to obtain the best results with each product.
-
Wrinkles and creases on the bag surface can prevent the package from reaching a satisfactory vacuum level as a small air quantity can be
sucked through them. To avoid such inconveniences, place the bag in spread conditions within the vacuum chamber.
-
Adjustments related to automatic operation are carried out in the factory in order to offer the best performances, both as for safety and
reliability. Should different performances be required in particular cases, operate the unit manually.
-
If you have not waited for the minimum time prescribed between connection to network and cycle starting, act as follows: unplug, plug
again and wait as long as required.
-
When containers are used particular attention should be paid to welding bar heating (7.) to prevent burns. -
recommend to operate manually when containers are used and the vacuum gauge pointer (3.) reaches the limit of the yellow area.
-
In case of deterioration, let the plug cable be replaced by a qualified electrician with the same type of cable
TECHNICAL CHARACTERISTICS
Code
Model
Body
Pump
Max. Power Absorbed
Max vacuum level
Aspiration
Outlet for canister attachment
Vacuometer
Potentiometer
Filter for EMC
Fuse 6A
Spare Fuse 6A
Led
Liquids Protection Filter
9709 NE
Professional 30 Eco
Stainless Steel
One cilinder Energy saving
200 W
-850 mbar
18 lt/min
YES
YES
NO
YES
YES
YES
2
NO
9709 N
Professional 30
Stainless Steel
Twin cilinder Energy saving
280 W
-900 mbar
30 lt/min
YES
YES
YES
YES
YES
YES
1
NO
For safety reasons, we
9709 NF
Professional 30 Filter
Stainless Steel
Twin cilinder Energy saving
310 W
-900 mbar
40 lt/min
YES
YES
YES
YES
YES
YES
1
YES
Publicité
Table des Matières
