Dismount And Disconnect The Drive - Toshiba Canvio Slim Mode D'emploi

2. Now, plug the USB 3.0 micro-B connector into the corresponding port of
the drive itself.
< Windows PC >
Immediately,
< Mac >
Immediately,

Dismount and disconnect the drive

It is strongly recommended not to unplug the drive by just unplugging the
cable connection as it may be that data is written to the drive at that time.
Such data will be lost and the drive may be damaged physically!
Please follow the steps below for a safe dismount of the drive.
< Windows PC >
1. Click the "Hardware and Eject Media – icon"
2. Select the TOSHIBA drive to eject.
3. Click "OK" and you can unplug the drive now.
< Mac >
Ctrl-click on the hard disk icon and choose "Eject".
OR
Drag the hard disk icon to the trashcan.
You can unplug the drive now.
Cleaning the drive case / enclosure
Before cleaning the drive, make sure that it's physically disconnected from
the computer. We suggest to use standard products for cleaning it and to
make sure that possible remaining liquid on the surface will be wiped off.
User's Manual
the Power/Data indicator light will illuminate
the drive will power up
the drive should mount and a new drive icon should appear in "My
Computer"
the Power/Data indicator light will illuminate
the drive will power up and is ready to use
A pop-up message box will appear listing the external devices
connected to your computer.
After a few seconds, you will get the notification that it is now safe to
remove the device.
CANVIO SLIM
EN-5