Dupla MARIN Ocean Lux 81495 Mode D'emploi page 5

Installation: Fix the lamp in the desired location on the
aquarium. The brackets can be adjusted to the required
length. For secure installation, be sure to leave at least
3 cm of the brackets inside the LED lamp.
Install the lamp on the aquarium so it is protected from
splashing water. Then connect the VG Ocean Lux 20 W
to the Ocean Lux LED 15 W lamp. When connecting
the two cables be sure the connectors are fitted correctly.
Then connect the power supply to a mains socket.
Operation: The daily on times can easily be
controlled with a timer switch or the Ocean
Lux LED Controller. Clean the Ocean Lux
LED 15 W with a soft, damp cloth. Disconnect
the mains plug and allow the LED lamp to cool
down before cleaning the LED light.
Connecting the Ocean Lux LED Controller:
Use the Ocean Lux LED Controller to easily program natural simulations of daylight and moonlight.
The Ocean Lux LED Controller will simultaneously control two Ocean Lux LED lamps.
Please refer to the Ocean Lux LED Controller instructions for installation.
Connecting an Ocean Lux LED 15 W to the Ocean Lux LED Controller for programming
simulated daylight and moonlight:
1. Ocean Lux LED channel 1 + 2
2. Ocean Lux LED channel 3 + 4
3. Ocean Lux LED 15 W lamp connection
4. Ocean Lux LED 15 W lamp connection
5. USB connection for PC
6. VG Ocean Lux LED 20 W
1. 2. 3. 4. 8.
5.
7. Connecting cables* (included with
the Ocean Lux LED Controller)
8. Ocean Lux LED Controller* (Item no.: 81506)
* not included, sold separately
7.
6.
3.
Note: The VG Ocean Lux LED 20 W ballast is only suitable for operating LED lamps. Never install the VG Ocean Lux LED 20 W
ballast on or inside the cover frame. Only operate the power supply / Ocean Lux LED 20 W ballast with compatible
components (Ocean Lux LED, Ocean Lux LED Controller, connecting cable).
+49 (0)22 25 - 94 15 0 · info@ dohse-aquaristik.de · www.dupla-marin.com