Dishwasher Won't Fill; Dishwasher Has An Odor; Removing Spots And Film; Error Codes - Electrolux Home Products EWDW6505GS Guide D'utilisation Et D'entretien

DISHWASHER WON'T FILL

• Check to see if the water supply is turned on.
• Add 1/2 cup of water to the bottom of the unit
and start again.

DISHWASHER HAS AN ODOR

• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
• There will be a "new" smell when first
installed. This is normal.
• Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
20).
REMOVING SPOTS AND
FILM
Hard water can cause lime deposit build-up on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2 Do not add detergent.
3 Select the NORMAL WASH cycle. Press
START/CANCEL pad and close door.
4 Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
5 Close and latch door and allow cycle to
finish.
NOTE
If these conditions persist, a home water
softener should be considered.
Solutions to Common Problems

ERROR CODES

In certain situations which are critical to the
machines function and safe operations.
Error 01
Leak Detector - When water is detected under
the tub.
Error 02
Thermistor - When thermistor/turbidity module
fails
Error 03
Wash Pump - Wash pump not operating
Error 04
Drying Damper - Drying damper not operating
Error 05
Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan
Error 06
Lower Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the lower fan
Error 07
Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve
Error 08
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Error 09
Communications - Communication failure be-
tween main user board and power supply
Error 10
Mains Relay - Failure in the mains power relay
Error 11
Drain Valve - Time out before finding a state for
the drain valve
Error 12
Drain Valve - The drain valve is running when it
should be off
Error 13
System wide - Lost control of the State Machine
21