Replace Logic Board Brace - Sonnet Encore/ZIF G3 Notice De Montage Et D'utilisation

En
5. Reconnect the internal drive(s) power cable
(Figure 25).
6. After the cables are reconnected, they should
appear approximately like the picture shown
in Figure 26.
• Internal drive(s) power cable
(Figure 26-Label A)
• Main SCSI cable (Figure 26-Label B)
• Secondary SCSI cable (Figure 26-Label C)
• Logic board power cable (Figure 26-Label D)

Replace Logic Board Brace

1. Replace the logic board brace (Figure 27) into
the interior of the computer and attach it with
the top and bottom brace screws.
2. Secure the main SCSI cable into the clamp on
the logic board brace and lock it into place
(Figure 28).
internal drive(s)
power cable
Figure 25; Figura 25
D
A
C
Figure 26; Figura 26
logic board brace
Figure 27; Figura 27
Figure 28; Figura 28
B
clamp
1-11