1
Screw the lower stand bar into the base
and rotate clockwise until secure.
3
Unscrew the top stand connector from the
upper and middle stand bars.
5
Unscrew the stand connector then insert
the middle stand bar into the lower stand
bar, aligning the A and B tabs, as shown
above.
K8000_09IM1214_22May_V11.indd 9
ASSEMBLY
2
Slide the amp down over the lower stand
bar.
4
Lower the top stand connector and rotate
clockwise to tighten.
6
B
A
B
Lower the stand connector and rotate
clockwise to secure.
A
9
B
B
A
A
22/05/2014 2:43 PM