Royalty Line PSC-700W.76NE.116 Mode D'emploi page 21

not overfill. Switch 'OFF' and unplug before emptying the dust
cup.
To remove the cyclone and clear dust cup unit, push the release
button to the end of the carrying handle, as shown.
Remove the cyclone and clear dust cup.
To release the dirt, push the slip release button.
To minimize dust/allergen contact when emptying, encase the
clear dust cup tightly in a plastic bag and empty.
Remove the clear dust cup carefully.
Seal the bag tightly, dispose as normal.
Close the clear dust cup base so it clicks into place and is secure.
Place the clear dust cup and cyclone unit into position on the
front of the main body of the appliance. The recess in the base
of the clear dust cup must fit onto the lug on the locator bracket.
Push the carrying handle down so it clicks into place on the top
of the clear dust cup and cyclone unit. Ensure it is secure.
CLEANING THE DUST CUP
Remove the cyclone and dust cup, and then open the dust cup
base (see 'Emptying the clear dust cup' above).
To separate the cyclone unit from the clear dust cup, push the
button on the clear dust cup body until the two parts are separated.
Clean the clear dust cup with cold water only.
Do not use detergents, polishes or air fresheners to clean the
clear bin.
Do not put clear dust cup in a dishwasher.
Do not immerse the whole cyclone in water or pour water into it.
Ensure the clear dust cup is completely dry before replacing.
To replace, first close the clear dust cup base so it clicks into place
and is secure.
Fit the clear dust cup on to the cyclone. To secure it, first fit the
slot on the front rim of the clear dust cup onto the lug on the
front of the cyclone; then push the rear of the clear dust cup into