Cleaning And Storage; Emptying The Dust Container - Lakeland 02243 Mode D'emploi

3. Press the On / Off switch (1) to switch on the device. The device starts to vacuum and
the UV-C lamp (10) switches on.
You can look through the viewing window (4) to check whether the UV-C lamp
is switched on.
4. Press the vibration button (14) to activate the vibration head (9).
The vibration shakes up the surface which is to be cleaned and the dust which
is agitated is sucked in through the suction opening (13).
5. Guide the device over the surface to be cleaned.
6. After vacuuming, press the On / Off switch to switch off the device.
7. Remove the mains plug from the plug socket.

Cleaning and Storage

PLEASE NOTE!
■ Empty the dust container each time after you use the device. The fi lters must also be
regularly cleaned in order to prevent overloading of the motor.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These can damage the surface.
• Make sure that the mains plug has been pulled out and the device is disconnected
from the power.
• As required, wipe down the motor unit with a damp soft cloth. Then dry it with a soft
cloth.
• Wipe out the recess for the dust container (5) with a duster.
• Store the device in a dry, cool place that is not accessible to children and animals.

Emptying the Dust Container

1. Reach into the recess in the dust container (5) and pull it up and out of the motor
unit (3).
2. Reach into the opening and pull the fi lters out of the dust container.
3. Empty the dust container.
4. Wipe out the dust container with a dry duster if necessary.
Cleaning the Dust and HEPA Filters
02243_DE-EN-FR-NL_A5_V2.1.indb 17 02243_DE-EN-FR-NL_A5_V2.1.indb 17
17
5. Unscrew the dust fi lter (15) anticlockwise until the arrow
on the dust fi lter points to the open padlock symbol (see
picture).
6. Detach the dust fi lter from the HEPA fi lter (16).
7. Tap out both fi lters and clean them with a soft brush if
necessary. Please note: For thorough cleaning the fi lters
can be rinsed under cold (!) running water.
NOTICE: Allow both fi lters to dry completely before the
device is reassembled.
EN
09.04.2019 16:32:47 09.04.2019 16:32:47