Cleaning The Uv-C Lamp; Troubleshooting - Lakeland 02243 Mode D'emploi

EN
8. Place the dust fi lter on the HEPA fi lter.
9. Screw on the dust fi lter clockwise until the arrow on the dust fi lter points to the closed
padlock symbol.
10. Insert the fi lters into the dust container (5).
11. Insert the dust container with the fi lters into the motor unit (3).

Cleaning the UV-C Lamp

PLEASE NOTE!
■ CAUTION – Danger of Burns! The UV-C lamp will become hot during use. Allow the
UV-C lamp to cool suffi ciently after using the device.
1. Undo the two screws on the cover (11) of the UV-C lamp (10) and take off the cover.
2. Wipe down the UV-C lamp with a dry duster. NOTICE: Make sure that you do not
touch the UV-C lamp with your fi ngers!
3. Place the cover back on and fi x it in place with the two screws.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair a electrical device yourself!
Problem
The device
generates no
suction.
Low suction
force.
The UV-C
lamp (10) does
not light up.
The vibration
head (9) does
not vibrate.
02243_DE-EN-FR-NL_A5_V2.1.indb 18 02243_DE-EN-FR-NL_A5_V2.1.indb 18
18
Possible cause / solution / tips
• Is the mains plug inserted in the socket correctly? Correct the
fi t of the mains plug.
• Is the plug socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the device switched on? Press the On / Off switch (1).
• Is the dust container (5) too full? Empty the dust container.
• Are one or both fi lters heavily clogged up? Clean the fi lter(s).
• Is the suction opening (13) blocked? Switch off the device, pull
the mains plug out of the plug socket and remove the blockage.
• The automatic switch-off function of the UV-C lamp has been
activated. Check the safety switches (see the "Safety Devices"
chapter).
• The automatic switch-off function has not been activated. The
UV-C lamp or the device is defective. Contact our customer
service department.
• Has the vibrating function been switched on? Press the vibra-
tion button (14).
09.04.2019 16:32:47 09.04.2019 16:32:47