Ayce LC125MS-1 Traduction De La Notice Originale page 74

3. Operation for working
a. Sanding
The sander can be used for most sanding operations on materials such as wood,
plastic, metal and painted surfaces.
! Don't use this machine on plaster.
Wear safety goggles and dust mask.
Where possible, secure smaller work-piece to prevent them from
moving under the sander.
WARNING
Lower the sander in contact with the work-piece without pressure and
then start the sander. Move the sander slowly over the surface of the work-piece in a
circular or curved motion with an even, moderate pressure.
If there are still scratches on your work after sanding, try either of the following:
• Go back to a coarser grit and sand the marks out before recommencing with the
original choice or,
• Try using new sanding sheet of the same grit to eliminate the unwanted marks
before progressing to a finer grit and finishing the job.