Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INTENDED USE
The machine is intended for dry sanding with suitable grained abrasive papers.
SPECIAL SAFETY INSTRUCTIONS
1. Hold power tools by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring. Contact with
a" live" wire will make exposed metal parts of the tool live and shock the
operator.
2. WARNING: Contact with or inhalation of harmful / toxic dusts arising from
sanding painted surfaces, woods and metals can endanger the health of
operator and bystanders.
3. Take protective measures when dust can develop during working that is
harmful to one's health, combustible or explosive. Example: Some dusts
are regarded as carcinogenic. Wear a dust mask and work with dust/chip
extraction when connectable.
4. Take special care to guard against these dusts, including the following:
• All persons entering the work area must wear an approved mask specially
designed for protection against harmful / toxic dusts, in addition to using the dust
extraction facility, and keeping work area well ventilated.
• Children and pregnant women must not enter the work area.
• Do not eat, drink or smoke in the work area. Any pre1960 building may have paint
containing lead on wood or metal surfaces. If you suspect work-piece contains
lead seek professional advice.
5. Some wood and wood type products especially MDF (Medium Density
Fibreboard) can produce dust that can be hazardous to your health. We
recommend the use of an approved face mask with replaceable filters when
using this machine in addition to using the dust extraction facility.
6. Hold the machine correctly using two hands and adopt a stable stance, make
sure that the mains cable is prevented from coming into contact with the
machine or getting caught up on other objects preventing completion of the
sanding pass.
7. This tool is intended to remove surface material using an abrasive medium.
8. Ensure that you have removed foreign objects such as nails and screws from
the work-piece before commencing sanding.
9. Do not use it for wet sanding, for dry sanding only.
10. Where possible, secure smaller work-pieces to prevent them from moving
under the sander.
11. Do not force the sander, let the tool do the work at a reasonable speed.
Overloading will occur if too much pressure is applied and the motor slows
Publicité
Table des Matières
