Duux Whisper Flex Mode D'emploi page 5

(optional) To extend the height of the fan,
7
connect the male pins of the extension tube
(part 3) to the female connectors on the base
and lower side of the motor. To release the
tube (part 3), press the buttons on the bottom
and back side.
Installing the remote control
Remove the lid
1
Place the battery according to the instructions
2
on the lid with the correct polarity
Close the lid
3
Note:
• Only use 1x CR2025 3V batteries
• Non-rechargeable batteries are not to be
recharged
• Exhausted batteries are to be removed from the
remote control and safely disposed of
• If the remote control is to be stored unused for a
long period, the battery should be removed
• The supply terminals are not to be short-circuited.
8
Installing the dock + battery pack
Note: For models DXCF10/11 the battery and
dock are sold separately (model no. DXCFBP01) and
are therefore not included.
Open the battery hatch on the bottom of the
1
base unit by switching the lock position to
"unlock" and remove the lid.
Place the battery according to the instruction
2
inside the battery hatch with the correct
polarity
h
Close the battery hatch by placing back the lid
3
and switching the lock position to "lock"
Battery hatch
Lock
Dock insert
3. Maintenance
Important: Always unplug the device from the
mains before cleaning. To maximize the efficiency
of the device, clean regularly
Cleaning the body
Use a soft, damp cloth to wipe the body clean.
Never use aggressive chemicals, gasoline,
detergents, chemically treated cloths, or other
cleansing solutions. These all could possibly hurt
the casing material.
CLOSE OPEN
1
Cleaning the fan blades
Follow below instructions to clean the fan
1
blades:
Remove the screw from the underside of the
2
grill
Rotate the outside cover to unlock the grill and
remove it
Disassemble the fan blades from the motor as
3
shown in the picture.
CLOSE OPEN
2 3
9