Optional Accessory - Makita DUT130 Manuel D'instruction

Installing the shaft

Optional accessory

For DUT130
1. Tighten the shaft into the shaft holder.
1
► 1. Shaft 2. Shaft holder
2. Tighten the shaft with wrench 19 while holding the
shaft holder with another wrench 19.
2
1
► 1. Shaft 2. Shaft holder
For DUT131
1. Insert the shaft into the chuck as far as it will go.
2
1
► 1. Shaft 2. Chuck
2
8 ENGLISH
2. Tighten the chuck by hand, and then place the
chuck key in each of three holes and tighten it clock-
wise. Be sure to tighten the chuck key at all three holes
evenly.
1
2
► 1. Chuck key 2. Chuck
To remove the shaft, turn the chuck key counterclock-
wise at one of the holes, and then loosen the chuck by
hand.
Installing the mixing blade
Optional accessory
Attach the mixing blade on the top of the shaft, and then
secure it with the hex bolt.
► 1. Mixing blade 2. Shaft 3. Hex bolt
NOTICE:
Be sure to attach the mixing blade with
"UP" mark facing the tool.
1
► 1. Mark
1
2
3