Cable Connections - Mitsubishi Electric QAHV Série Manuel D'installation & D'instructions

[3] Cable Connections

<1> Schematic Diagram of a Unit and Terminal Block Arrangement
To remove the front panel of the control box, unscrew the four screws and pull the panel forward and then down.
Power supply
terminal block
Cable strap
<2> Installing the conduit tube
• Punch out the knockout hole for wire routing at the bottom of the front
panel with a hammer.
• When putting wires through knockout holes without protecting them
with a conduit tube, deburr the holes and protect the wires with
protective tape.
• If damage from animals is a concern, use a conduit tube to narrow the
opening.
Cable strap
Power wire
Transmission cable
Power wire
GB-55
Control terminal block
Transmission cable
Fix in place with a cable tie.
Knockout hole
Burr