Bigben Interactive Colorlight Mode D'emploi page 13

Operation
1. Connect the AC adapter to the base.
2. Connect the AC adapter to the power outlet.
3. LED 4 turns red to indicate standby mode.
Bluetooth speaker function
• Briefly press button 2 to turn on bluetooth: LED 4 will flash blue, and an audible signal will
indicate that the power is on.
• Switch your device to bluetooth mode, search for "Chevalet" and click to connect. A beep
will sound when the connection is established, and LED 4 turns blue. You can then listen
to music from this speaker.
• Briefly press button 2 again. Bluetooth turns off and LED 4 turns red, and a beep indicates
that Bluetooth is turned off.
Comment: in STANDBY MODE, Bluetooth turns off automatically after 15 minutes
without connection.
Lighting function
• Short-press button 1 to activate the light.
• Short-press button 1 again to adjust the brightness. The sequence is as follows:
10% brightness ► 30% brightness ► 100% brightness ► Repeat
• Long-press button 1 to turn off the light with the current light setting.
Lighting programmer
There is an LED indicator on the side to indicate the chosen duration.
• Press button 3 once: the green light comes on, the programmer is set for 15 minutes.
• Press button 3 twice: the orange indicator lights up, the programmer is set to 30 minutes.
• Press button 3 three times: the red light comes on, the programmer is set for 60 minutes.
• Press button 3 four times: the indicator goes off, the programmer is off.
- EN 13 -