Bigben Interactive Colorlight Mode D'emploi page 10

Getting started
Safety warning and notice
Package contents
Description of parts
Operation
Getting started
• Take the appliance out of the box
• Remove all the packaging from the product.
• Place the packaging inside the box and either keep or dispose of properly in compliance
with the waste sorting instructions shown on the product packaging.
Safety warning and notice
You must read and understand all the instructions before using this appliance. The warranty
will not apply if damage is caused by failure to follow the instructions.
1. Never remove the appliance casing.
2. Never place this appliance on other electrical equipment.
3. Protect the power cord from being walked on or pinched, particularly at the
plugs, sockets, and the point where it exits the appliance. Make sure that
the power voltage corresponds to the voltage shown on the rating plate
at the rear of the appliance. Always pull the plug from the socket when
disconnecting from the mains. Never pull on the cord. Ensure you have
completed all the other connections before connecting the plug.
4. Only use attachments/accessories that are recommended by the
manufacturer.
5. Entrust all appliance repairs to qualified repairers. A repair is needed
when the appliance has been damaged in any fashion, and in particular:
- if the power cord is damaged;
- in the event of a liquid spill or objects being inserted into the device;
- if the device is exposed to rain or humidity;
- if the device does not operate normally;
- or if the device has been dropped.
6. The rating plate is located on the underside of the appliance.
7. Never block the air vents.
8. Make sure you have sufficient, stable space around the device for ventilation.
9. This device should be used in a temperate environment, away from direct sunlight,
naked flames or heat, heaters, stoves or any other device (including amplifiers) that
generates heat. Do not install it near heat sources.
10. The batteries (battery pack or inserted batteries) must not be exposed to excessive
heat, such as sunshine, fire, etc.
11. Always unplug the device before cleaning it. Never lubricate any part of this appliance.
10 Technical specifications
10 Care for the environment
12 Additional information
12 Declaration of conformity
13
- EN 10 -
14
14
15
15