Bosch sensixx B10L Notice D'utilisation page 17

Trouble shooting
Problem Possible causes
The steam generator • There is a connection problem.
does not come on. • The main power button is not
The iron does not • The main power button is not
heat up.
• The temperature control knob is set
The iron begins to • During first use: Certain
smoke when switched
on.
• During later use: the soleplate may
Water flows through • The steam function is being used
the holes on the sole
plate. • The water is condensing inside the
Dirt comes out • There is a build-up of scale or
through the sole plate.
• Chemical products or additives have
The iron does not • The boiler is not switched on or is
produce any steam.
• The steam regulator is set to the
The ironed garment • The selected temperature is too
turns dark and/or
sticks to the soleplate.
The soleplate turns • This is a regular consequence of
brown.
Loss of pressure Steam release button activated
during ironing. during a long period of time.
If the above does not solve the problem, get in touch with authorized technical service.
You can download this manual from the local homepages of Bosch.
switched on.
switched on.
to the "min" position.
components on the appliance have
been lightly greased at the factory
and may produce a little smoke
when initially heated.
be soiled.
before it has reached temperature.
pipes because steam is being used
for the first time or has not been
used for a long time.
minerals in the boiler.
been used.
empty.
minimum position.
high and has damaged the garment.
usage.
Solution
• Check the mains cable, the plug
and the socket.
• Switch the main power button (9) to
the on position.("I")
• Switch the main power button (9) to
the on position.("I")
• Set the temperature control knob
(11) to the desired position.
• This is completely normal and will
stop after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (8*)).
• Point the iron away from the ironing
area and press the steam release
button (12) until steam is produced.
• Clean the boiler
Use tap water mixed 50% with
distilled or demineralised water. If
the tap water in your district is very
hard, mix tap water with distilled
water 1:2.
• Clean the sole plate with a damp
cloth.
• Never add products to the boiler
• Switch the main power button (9) to
the on position.("I") and/or fill the
boiler
• Increase the steam flow by turning
the steam control (8*).
• Select a suitable temperature for the
material and clean the sole plate
with a damp cloth.
• Clean the soleplate regularly with a
damp cloth.
Use the steam release button (12)
with intervals. This improves the
ironing result as the textiles will be
dried and stay smooth better.
17
BOSC H