When power is first supplied to the microwave oven, ":" will
appear in the display. If the ":" appears in the display at any other
time, a power failure has occurred. Reset the clock if needed.
While the microwave oven is being programmed, the display
shows cooking power, quantities, weights and/or prompts. When
the microwave oven is not in use, the display shows the time of
day (if the Clock is set) or Timer countdown.
The START pad begins any function. If cooking is interrupted,
touching START will resume the preset cycle.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 5 minutes or more. "DOOR" will
appear in the display until the door is opened and closed.
The CANCEL pad clears any incorrect command and cancels any
program during cooking. It will not erase the time of day.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.
Add A Minute
The ADD A MINUTE pad starts the microwave oven for 1 minute
at 100% power. More cook time may be added in 1-minute
increments by touching ADD A MINUTE repeatedly.
The Add A Minute function may be used only when no other
function is operating.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 5 minutes or more. "DOOR" will
appear in the display until the door is opened and closed.
This is a standard 12-hour clock (12:00-11:59).
To Set:
The microwave oven must be off.
1. Touch CLOCK.
2. Touch number pads to enter correct time of day.
3. Touch CLOCK.
Display
Start
Cancel
Clock
NOTE: The Timer does not start or stop the microwave oven.
Cook functions may be used while the Timer is counting down.
When the cook function is active in the display, touch TIMER to
see the Timer count down for 5 seconds.
To Set:
1. Touch TIMER.
2. Touch number pads to enter desired time.
3. Touch START.
When the set time ends, the end-of-Timer tone will sound.
4. While the Timer countdown is active in the display, touch
CANCEL to cancel the Timer.
If a cook function countdown is active in the display, touch
TIMER to show the Timer countdown, then touch CANCEL to
cancel the Timer. Touching CANCEL while a cook function
countdown is active in the display will cancel the cook
function, not the Timer.
Tones are audible signals that can be turned off.
To Turn Off/On All Tones: Touch and hold POWER LEVEL for
5 seconds, until "Off" appears in the display. Repeat to turn
tones back on ("On" will appear in the display).
These tones indicate the following:
One tone
Valid entry
End of Timer (long tone)
Two tones
End of stage in multistage cooking
Control Lock active (short tones)
Three tones
End of cycle
Five tones
During Defrost cycle, reminder to check, turn, rearrange, or
separate food
Control Lock
The Control Lock disables the control panel pads to avoid
unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must be off.
Touch and hold CANCEL for 5 seconds until the tones sound and
the LOCK icon and "LoC" appear in the display. Repeat to unlock
and clear the display (2 tones will sound).
If any cook function control is touched while the Control Lock is
active, "LoC" will appear briefly in the display and 2 tones will
sound.
Timer
Tones
7