Disposal Notes - Olympia PS 406.2C Mode D'emploi

Problem
Device does not work
Device does not work after
lengthy operation or
stops during operation
Paper jam
This symbol [the crossed-out wheeled bin/PICTURE] means that the
product should be brought to the return and or separate collection sy-
stems available to end-users, when the product has reached the end
of its lifetime.
This symbol applies only to the countries within the EEA (*).
(*) EEA = European Economic Area, which comprises the EU Member
States plus Norway, Iceland, and Liechtenstein.
Device malfunctions
Cause
Is the mains cable plugged
properly in the socket?
Is the switch set to ON?
Does the motor not start
when paper is fed in?
Was the device in constant
operation for some time?
Is the surface of the device
warm?
Have you inserted
more than 6 sheets
(406.2C) / 15 (415.4C)
Has the paper not been
inserted straight in the in-
feed slot?

Disposal Notes

Remedy
Plug the mains cable into
the socket properly.
Set the switch to ON.
The lamp Power shines.
Push the paper into the in-
feed slot so that it touches
the sensor in the centre.
Pull out the mains plug
from the socket and allow
the motor to cool down to
room temperature.
Push switch REV
to push back the paper.
Release Switch REV
to shred the paper remai-
ning in the cutting unit.
9