Marvel MP24FAS4 Série Instructions D'installation, D'utilisation Et D'entretien page 13

OVERLAY DOOR PANEL INSTALLATION
Step 2: Remove the door gasket
With the door laying on a flat surface and starting
at a corner of the door remove the magnetic door
gasket from the interior side of the door, see
Figure 13. Set the gasket aside on a flat surface.
There are 10 holes in the gasket retainer extru-
sions, (3 on each side and 2 at the top and bottom
which are used to fasten the panel to the front of
the door. The screws are provided in the literature
pack.
Figure 12
Press and hold down this
tab on the wire connector
and pull the connector apart.
Holes in
gasket
retainer.
Figure 13a
Figure 13
13
Overlay panel flush
with top of door.
Overlay
panel to be
centered on
width of door.
Magnetic
Gasket remove
starting at a
corner, grasp
and pull away
from the door.