Remove Packaging From Built-In Models - GE Monogram ZGG300LC Instructions D'installation

REMOVE PACKAGING FROM BUILT-IN MODELS

1. Cut the banding. Use a box cutter or utility knife
to score and cut the carton along the base (or remove
the staples with a staple remover or a screwdriver).
2. Lift the carton straight up and off of the grill.
3. Remove all outside packing materials.
4. Remove the screws from the hold-down boards on
the skid. This will allow better access to the ends
when lifting the grill off the skid.
5. Open the lid. Cut plastic ties and bands. Remove
the parts package. Remove the grill grates and
packaging.
Installation Preparation
Cut the banding
with tin snips.
Score and cut.
Hold-Down
Boards
15
6. Close the lid. Cut the plastic tie holding the
wires against the left side. Let the battery
and transformer wires hang loose along the
back side.
Cut tie on the rear vertical support.
7. Lift the grill off the skid and slide it into the
prepared countertop opening.
8. Remove the tie holding the sear burner (on
some models). Lift the wire mesh cover on the
sear burner and remove packaging. Carefully,
replace the wire mesh cover. The wire mesh
must be wrapped around the vertical side
flanges of the burner.
Lift wire mesh and
remove packaging.
Replace wire
mesh cover.