König Electronic CMP-NWIPCAM21 Mode D'emploi page 4

CAM_EZ Search Screen:
IP CAM List
Renew List
IP CAM Name
IP address
Subnet Mask
Default Gateway
Communication Port
Audio UDP Port
6. Use IP-CAM and test the image function for the first time
 We recommend the following procedure to setup the CMP-NWIPCAM21 IP address and program settings.
The operation steps are listed below:
A. Installing the Product for the first time:
• Your computer must be equipped with a network card and RJ-45 network connector.
• Connect the RJ-45 terminator on the rear of the CMP-NWIPCAM21 to the red test network cable. One end
is connected to the network card of the computer; the other end is connected to the rear side of the CMP-
NWIPCAM21.
NOTEBOOK
B. Check if the IP addresses for the PC network and CAM_EZ Search are on the same network section:
• Usually, static IP address will be used to access to the internet, so the IP address will vary. When you want
to change the IP address, please write down the original IP address of your computer for testing if the CMP-
NWIPCAM21 can be operated normally or not. After finishing the test, the IP address for your computer should be
recovered to the original setting.
• In general, the IP address for your computer in your LAN will be set with "Auto Obtain IP address". To test if the
CMP-NWIPCAM21 is working, the IP address of your computer must be changed temporarily. After finishing the
test, it can be recovered to original settings.
C. Next, choose Control Panel -> Network Connections -> choose the highlighted area.
Network connections -> right click your mouse -> select Properties (P) -> Select Internet Protocol (TCP/IP) -> Select
Properties (R), then you can check the current IP address status for the computer. The way to modify the IP address
is:
Figure (1)
IP CAM
4
Version of
CAM_EZ
Search
Display the
way to get IP
Version of IP
CAM
Choose the
way to get IP
MAC address
PPPoE Account
Key in PPPoE
Renew
Executed to
obtain an IP