Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION OF MAIN PARTS (Fig.1)
Fig.1
1.
Motor housing
3.
Lower handlebar
5.
Handlebar securing knob
7.
Switch lever
9.
Cable retainer
11. Deck
13. Height adjustment lever
ASSEMBLY
1)
Mounting the handlebar
−
Put the cable hook on upper handle.(Fig.2)
−
Connect upper and lower handles with supplied screws and knobs. (Fig.3)
−
Insert the two lower handlebar tubes into the holes on main body. And fix it with lock
screw (15) (Fig.4.1-Fig.4.3))
−
Fix the cable holders(9) on handlebar.(Fig.5)
2) Fix the wheel
−
Fit each wheels over the axles, secure in place with the washer & nut and press the
wheel covers into place.(Fig.6)
3) Fitting the grass catcher
−
Assemble two halves and fix them together.(Fig.7)
−
Lift the flap and place the grass box over the lugs.(Fig.8)
OPERATION
Setting the cutting height (Fig.9)
NOTE: Stop, release switch lever and wait until the motor stops before adjusting
height, the blades continue to rotate for a few seconds after the machine is switched
off, a rotating blade can cause injury.
For the first cut of the season .a high cutting adjustment should be selected.
The cutting height can be selected among 20 mm, 70 mm ,
1.
To raise the blade height, grasp the height adjustment lever and move it toward the
back of mower.
2.
To lower the blade height, grasp the height adjustment lever and move it toward
the front of mower.
Power connection (Fig.10)
2.
Grass catcher
4.
Upper handlebar
6.
Safety button
8.
Rear deflector
10. Wheel
12. Cable clip
14. Switch box
16
Publicité
Table des Matières
