Package Contents; Description (Fig. A) - Berner BHD-5 Mode D'emploi

E N G L I S H
Warning! The use of any accessory or
attachment or performance of any operation
with this tool, other than those recommended in
this instruction manual may present a risk of
personal injury.
17 Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized BERNER repair agent. Inspect the
extension cords periodically and replace them if
damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment and
seizure of moving parts, breakage of parts and
any other conditions that may affect its operation.
Have damaged guards or other defective parts
repaired or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
BERNER repair agent.
20 Have your tool repaired by an authorized
BERNER repair agent
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.

Package contents

The package contains:
1 Rotary Hammer
1 Side handle
1 Depth adjustment rod
1 Tube of lubricant
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
16
• Take the time to thoroughly read and
understand this manual prior to operation.

Description (fig. A)

Your BERNER Rotary Hammer has been designed
for professional hammer drilling and light chipping,
chiselling and demolition applications.
1 On/off switch
2 Electronic speed and impact control dial
3 Service indicator
4 Type of operation – Option switch
5 Security lock
6 Tool holder for SDS-max
7 Collar
8 Side handle
9 Side handle clamp wheel
10 Rear side handle position
11 Depth adjustment rod
12 Rear handle
Soft start feature
The soft start feature allows to build up speed slowly,
thus preventing the drill bit from walking off the
intended hole position when starting. The soft start
feature also reduces the immediate torque reaction
transmitted to the gearing and the operator if the
hammer is started with the drill bit in an existing hole.
Torque limiting clutch
All Rotary Hammers are equipped with a torque
limiting clutch that reduces the maximum torque
reaction transmitted to the operator in case of
jamming of a drill bit. This feature also prevents the
gearing and electric motor from stalling. The torque
limiting clutch has been factory-set and cannot be
adjusted.
Electronic speed and impact control (fig. B)
The electronic speed and impact control (2)
offers the following advantages:
- use of smaller drill bits without risk of bit breakage
- drilling into light and brittle materials without
shattering
- optimal tool control for precise chiselling
®
accessories