ISOUND DuraWaves Glow XL Guide De L'utilisateur page 6

will turn orange.
NOTES:
• Please replace protection cover a er charging.
• When the ba ery level is below 20%, you will hear a voice
saying "Ba ery level low", and the volume will lower
automatically to conserve ba ery.
• Charge your DuraWaves Glow XL with the included charge
cable.
Connecting via Bluetooth® ( rst time set-up)
1. Pull up the protection cover of the DuraWaves Glow XL on
the back of the speaker.
2. Power on the speaker by moving the power switch om
"OFF" to "ON".
3. Open the se ings on your Bluetooth device. (Bluetooth must
be enabled).
4. Select DuraWaves Glow XL om the devices list.
5. Once paired, you will hear "Bluetooth paired" and the
Bluetooth LED indicator will remain solid blue.
6. Volume can be adjusted separately om your device or
the speaker.
NOTES:
• Please replace protective cover a er powering on speaker.
• Your device will automatically nd and pair with the
DuraWaves Glow XL a er the initial pairing. If your device does not
automatically pair, turn o the speaker and repeat steps 1-5.
• The speaker will start in the mode it was in when the speaker
was turned o . If the speaker is in a mode other than Bluetooth
mode, press the mode bu on until you hear "Bluetooth mode".
The Bluetooth LED indicator will rapidly ash blue.