Black & Decker BDCDE120 Manuel D'instructions page 7

heard (figure B). Ensure battery pack is
fully seated and fully latched into position.
TO rEmOvE BATTErY pACk: Depress
the battery release button (6) as shown in
figure c and pull battery pack out of tool.
B
c
oPeraTInG InSTrucTIonS
TrIGGer SwITcH & reverSInG
BuTTon (fIGure d)
• The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the higher
the speed of the drill.
• A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
• To select forward rotation, release the trigger
switch and depress the forward/reverse
control button to the left.
• To select reverse, depress the forward/
reverse control button the opposite
direction.
noTe: The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
d
2
1
All manuals and user guides at all-guides.com
drIll / drIve Mode SelecT (fIGure e)
This drill is equiped with mode select
buttons (3) to quickly and easily change
the performance of the tool to drilling or
driving based upon your project.
• To set the tool to drive mode, press the
• To set the tool to drill mode, press the
noTe: A blue LED will light the symbol for
the mode that is selected.
STaTe of cHarGe IndIcaTor
(fIGure e)
The drill is equipped with a state of charge
indicator. This can be used to display the current
level of charge in the battery during use. It does
not indicate tool functionality and is subject
to variation based on product components,
temperature, and end-user application.
checking state of charge during use:
• Insert the battery (5) into the tool as
• press both mode select buttons (3) or
• The four green lEDs will illuminate, indicating
noTe: The state of charge LEDs will also
light when the trigger is pulled to indicate
the state of charge while the drill is in use.
SInGle Sleeve keyleSS cHuck
(fIGure f)
button is engaged to prevent switch actuation
before installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the handle of the drill with one
7
button marked with the
button marked with the
shown in figure B.
depress the trigger switch (1).
the percent of charge in the battery. If all four
are lit, battery has a full charge. If lEDs do
not illuminate, charge battery.
3
e
warnInG:
Make certain the lock-off
hand and use your other hand to rotate
f
4
symbol.
symbol.
7