Black & Decker BDCDE120 Manuel D'instructions page 10

and you may have other rights which vary
from state to state or province to province.
should you have any questions, contact the
manager of your nearest Black & Decker
service Center. This product is not intended
for commercial use.
free warnInG laBel rePlaceMenT:
If your warning labels become illegible or
are missing, call 1-800-544-6986 for a free
replacement.
Problem
• Unit will not start.
• Battery pack will not
charge.
• AUTOSENSE Technology
doesn't work or stops
prematurely.
• Unit shuts off abruptly.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BlACk & DECkEr help line at 1-800-544-6986.
All manuals and user guides at all-guides.com
laTIn aMerIca: This warranty does not
apply to products sold in Latin America. For
products sold in latin America, check country
specific warranty information contained in the
packaging, call the local company or see the
website for warranty information.
TrouBleSHooTInG
Possible cause
• Battery pack not installed
properly.
• Battery pack not charged.
• Battery pack not inserted
into charger.
• Charger not plugged in.
• surrounding air temperature
too hot or too cold.
• Tool in drill mode.
• Not enough pressure
when driving.
• AUTOSENSE Technology
disengaged.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
Imported by
Black & Decker (U.s.) Inc.,
701 E. Joppa Rd.
Towson, mD 21286 U.s.A.
10
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
• Insert battery pack into
charger until green LED
appears.
• plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4.5°C) or below
105 degrees F (+40.5°C).
• Ensure tool is in
screwdriver mode as
described in "Drill / Drive
Mode Select."
• Try again and apply
a substantial amount of
pressure to the back of
the tool.
• Release the trigger and
depress it again to
reactivate the
AUTOSENSE technology.
• Allow battery pack to
cool down.
• place on charger and
allow to charge.