Unpacking And Setting Up - SilverCrest SZW 400 A1 Mode D'emploi

All manuals and user guides at all-guides.com
RP75819 ZuckerWG LB1 Seite 57 Dienstag, 24. Juli 2012 9:14 09
•Should some sugar fall nonetheless
into the bottom section 9, proceed as
described in "8. Faults and remedies"
on page 60.
Note: As the appliance and heating
elements 5 are supplied with a thin film of
grease, there might be a small amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
1. Remove the individual parts from the
packaging.
2. Check that all the individual parts are
complete (see "1.2 Scope of supply" on
page 52) and there are no signs of
damage.
3. Clean the appliance thoroughly before
using it for the
"7. Cleaning" on page 59).
4. Place the candyfloss bowl 6 on the
bottom section 9.
5. Turn the candyfloss
anticlockwise so that the candyfloss
bowl engages in the locks 7.
SZW 400 A1

5. Unpacking and setting up

6. Position the carameliser 2 on the drive
shaft 4.
Note: There is a cross pin located in
the drive shaft 4. This cross pin must grip
into the lower indentation on the
carameliser 2.
first time (see
7. Position the splash guard 1 onto the
candyfloss bowl 6.
8. Place the appliance on a level, dry, non-
slip surface, so that the appliance can
6
bowl
neither topple over nor slide down.
7
4
57