For The Safety Of Your Child; Material Damage - SilverCrest SZW 400 A1 Mode D'emploi

All manuals and user guides at all-guides.com
RP75819 ZuckerWG LB1 Seite 56 Dienstag, 24. Juli 2012 9:14 09
items while the machine is working or
cooling down.
•The surfaces are liable to get hot
during use.
•Switch off and unplug the appliance
when changing accessories and
before approaching parts that move
when the appliance is operating.
4.5 Protection against the danger of fire
Warning! As the appliance
works at high temperatures, please
observe the following
information to prevent fire.
•Take great care that no sugar enters
the bottom section 9. Sugar can be
flammable and damage the
appliance. Should this happen at
some stage nonetheless, proceed as
described in "8. Faults and remedies"
on page 60.
•To avoid overheating, the appliance
must never be covered. Always check
that air can freely enter and escape.
Heat might otherwise build up inside
the appliance.
•Never leave the appliance running
when it is unattended. Damage is almost
always indicated by the presence of a
strong odour. If you notice any such
odour, unplug the mains plug
56
immediately and have the appliance
inspected. The contact data can be
found in "Service Centre" on page 62.

4.6 For the safety of your child

Warning! Children are often
unaware of danger and are injured
as a result. Please note therefore:
•Only allow children to use this appliance
under the supervision of an adult.
•Ensure the appliance is always kept
out of the reach of children.
•Ensure that children cannot pull the
safety
appliance down onto themselves with
the mains cable.
•Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.

4.7 Material damage

Caution! To avoid material damage,
please observe the following conditions.
•Place the appliance on a level, dry,
non-slip surface only, so that the
appliance can neither topple over nor
slide down.
•Sugar must only be added when the
carameliser 2 is stationary. If sugar is
added while the carameliser 2 is
rotating, it could be spun outwards
and could possibly enter the bottom
section 9.