Black & Decker BCF5252 Manuel D'instructions page 14

SET UP & USE
DOWNROD INSTALLATION
8. Insert motor wires through the selected downrod and insert the downrod into
the downrod coupling. Make sure to align the hole in the downrod with the hole
in the downrod coupling. Install cross pin (1) removed in step 6 through coupling
and downrod. Insert clamp pin (2) into cross pin until it snaps into place. Tighten
set screws (3) in coupling. Slide coupling cover (4) and canopy onto the downrod
above the coupling cover. PROCEED TO PAGE 15, STEP 9.
4
Page 14
2
2
3
1
1
Downrod Coupling
Downrod Coupling
3