Installation - Panasonic AW-PH400E Mode D'emploi

Roll Unit AW-RL400

Installation

Attach the pan-tilt head's rotary arm to the roll unit using the 3 mounting screws (M5 M 22 mm, with flat washers, pan-tilt
head accessory).
Attach the rotary arm to the pan-tilt head using the mounting screws (M5 M 22 mm, with flat washers, pan-tilt head accessory).
Loosen the 2 screws of camera mounting plate which is already installed to the roll unit.
Then remove the camera mounting plate.
Camera mounting plate
( consisting of 2 separate
sub plates)
p When assembling the units, use the Allen key (provided), wrench and screwdriver, and secure the units by tightening the
screws firmly. After mounting the units, check there is no play in the way they are mounted.
Rotary arm
Screws
53 (E)
Roll unit
Camera mounting plate
( consisting of 2 separate
sub plates)