3 - Remote control description
3.4 - Remote control configuration
The factory configuration can be modified by repositioning the configuration switches as shown
in the following table.
To access the switches, remove the remote control batteries door.
1
2
3
4
OFF
ON
Switch 1= ON
Switch 1
Switch 1= OFF
Switch 2= ON
Switch 2
Switch 2= OFF
Switch 3= ON
Switch 3
Switch 3= OFF
Switch 4= ON
Switch 4
Switch 4= OFF
To enable any changes made in the configuration, reset the
remote control by removing the batteries.
When a key is pressed the related LED will turn on
When a key is pressed the related LED will not turn on
When a key is pressed a "beep" will sound
When a key is pressed no "beep" will sound
Enters into configuration mode
Upon configuration completion, move the switch back to
the OFF position (normal operation mode)
future application
future application
27