Pioneer SGY-PM900H90 Mode D'emploi page 27

6
Press until the outer surface of the magnet ring (surface with markings) and the surface of the BB are in
the same position.
Use a level as you rotate the magnet rings to adjust them so they are level and the air bubble is centered.
7
Use a 2-mm hex wrench to tighten the screws (3) evenly.
Use a tool that can measure the torque to tighten the screws.
• Tightening torque: 1.0 N•m
•
Please note that tightening the screws leaves marks on the bottom bracket.
8
Remove the double-sided tape and the level.
Installing the Magnet Rings
27
EN