Pioneer SGY-PM900H90 Mode D'emploi page 17

3
Use your fingers to press down on the strain gauge unit's perimeter (diagram below) and the left-side
transmitter.
4
Remove the left sensor guide and the boss for the left crank from the guide base.
5
Insert the right sensor guide into the guide base.
See page 12 for the procedure.
•
Be careful that the double-sided tape on the strain gauge unit does not touch the adhesive.
6
Insert the right crank into the sensor guide and strongly press it in.
7
Slowly extract the right crank from the guide base.
8
Use your fingers to press down on the strain gauge unit's perimeter (diagram below) and the right-side
junction box.
EN
Attaching the Sensors
17