Adjusting Depth Of Cut; Bevel Cutting - Makita DHS680 Manuel D'instruction

Releasing protection lock
When the protection system works repeatedly, the tool
is locked and the battery indicator shows the following
state.
Battery indicator
015201
In this situation, the tool does not start even if turning
the tool off and on. To release the protection lock,
remove the battery, set it to the battery charger and wait
until the charging finishes.

Adjusting depth of cut

CAUTION:
After adjusting the depth of cut, always tighten the
•
lever securely.
1
2
015198
Loosen the lever on the side of the rear handle and
move the base up or down. At the desired depth of cut,
secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.

Bevel cutting

1
015105
Loosen the front lever. Set for the desired angle (0° -
50°) by tilting accordingly, then tighten the front lever
securely.
On Off Blinking
Protection lock works
1. Lever
2. Depth guide
1. Front lever
1
015116
Use the 45° stopper when you do precise 45° angle
cutting. Turn the stopper counterclockwise fully for bevel
cut (0° - 45°) and turn it clockwise for 0° - 50° bevel cuts.
Sighting
2
1
3
015106
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the 45°
position with it. The position of the top guide is adjustable.
Lighting the lamp
CAUTION:
Do not look in the lamp or see the source of lamp directly.
•
1
015154
Only to turn on the lamp, pull the switch trigger without
pressing the lock-off lever. To turn on the lamp and run
the tool, press the lock-off lever and pull the switch
trigger with pressing the lock-off lever. The lamp keeps
on lighting while the switch trigger is being pulled. The
lamp goes out 10 -15 seconds after releasing the trigger.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Do not use gasoline, thinner or the like to clean
•
the lens of lamp. Using such substances will
damage the lens.
9
1. Stopper
0-45
0-50
1. Cutting line
(0 ﾟ position)
2. Cutting line
(45 ﾟ position)
3. Screw
1. Lamp