Hex Wrench Storage - Makita DHS680 Manuel D'instruction

Hook
CAUTION:
Always remove the battery when hanging the tool
•
with the hook.
Never hook the tool at high location or on
•
potentially unstable surface.
2
015119
The hook is convenient for hanging the tool temporarily.
To use the hook, simply turn it until it snaps into the
open position.
When not in use, always turn the hook until it snaps into
the closed position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing saw blade
CAUTION:
Be sure the blade is installed with teeth pointing
•
up at the front of the tool.
Use only the Makita wrench to install or remove
•
the blade.
2
3
015108
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
1. Hook
1
2. Close
3. Open
3
1. Hex wrench
2. Shaft lock
3. Tighten
4. Loosen
4
1
1
2
015109
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
1 2
011231
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade, outer flange and hex bolt.
BE SURE TO
COUNTERCLOCKWISE SECURELY.

Hex wrench storage

1
015110
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
10
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex bolt
3
4
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
3
TIGHTEN THE HEX
1. Hex wrench
BOLT