Edge Guide - Ryobi CJSP-1801QEOM Manuel D'utilisation

GB
F D
OPERATION
HOW TO POSITION BASE IN THE SPLINTER-FREE
CUTTING POSITION
Remove battery pack.
■
Using the 3 mm hex key provided, loosen base pivot
■
screws and slide base forward. See Figure 9.
Always set the cutting angle at 0° for splinter-free
■
cutting. To set cutting angle at 0°, align the 0° mark
on the scale with the edge of the motor housing.
NOTE: When setting angle at 0° for splinter-free
cutting, the positive stop notches on the rear of the
base are not used.
Tighten base pivot screws securely.
■
Remove hex key and return it to storage compartment.
■
Replace battery pack.
■

EDGE GUIDE

See Figure 10.
An edge guide is available for use with your saw. It can be
used for making crosscuts and rip cuts.
Remove battery pack. Insert the arm through the two slots in
the base of your saw as shown in Figure 10. Adjust edge
guide to the desired width and lock in place with the edge
guide screw.
MAINTENANCE
WARNING
When servicing, use only Ryobi replacement parts.
Use of any other part may create a hazard or cause
product damage.
E I P NL S DK N FIN GR
English
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
DO NOT abuse power tools. Abusive practices can damage
tool as well as workpiece.
Have your tool repaired by a qualified person. This tool is in
accordance with the relevant safety requirements,
repairs should only be carried out by qualified person,
otherwise this may result in considerable danger to the user.
11
RO
H CZ RUS
WARNING
Do not at any time let brake fluids, petrol, petroleum-
based products, penetrating oils, etc. come in
contact with plastic parts. They contain chemicals
that can damage, weaken or destroy plastic.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
HR
PL SLO TR