Messages - Sony DSX-A310DAB Mode D'emploi

Messages

The following messages may appear or flash during
operation.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during iPod
playback.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
(underscore): The character cannot be
displayed.
For USB device playback:
HUB NO SUPRT: USB hubs are not supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 13).
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 17).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.
20
GB
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
For DAB/DAB+ radio reception:
NO DATA
 There is no DAB station for the selected program
type.
 Press
(back).
NO INFO
 There is no label information for the current DAB
station.
NO STATION: The DAB signal cannot be received.
 Perform an auto tune (page 8).
 Check the connection of the DAB antenna
(aerial).
 Check that [ANT-PWR] is set to [ON] (page 14).
RECEIVING
 The DAB source is selected and the unit is waiting
to receive a station.
For RDS operation:
NO AF: No alternative frequencies.
 Press / (SEEK –/+) while the program
station name is flashing. The unit starts searching
for another frequency with the same PI (program
identification) data ([PI SEEK] appears).
NO PI: No program identification. The selected
station has no PI (program identification) data.
 Select another station.
NO TP: No traffic programs.
 The unit will continue searching for available TP
stations.