Operation; Switching On; Switching Off; Restart - Bosch 1 687 023 634 Notice Originale

en �� | � ��� ��� ��� | Description of unit
�.�

Operation

�.�.�

Switching on

¶
To switch on, press the on/off switch on the front of
the PC.
 The PC ready LED lights up.
i
With Bosch inspection and testing products in which
this PC was installed, you must switch on the PC
using the central mains switch on the socket strip.
The socket strip is located on the rear of the trolley.
It is used to switch on all components simultane-
ously (monitor, PC). Prior to this, the individual
mains switches of all components must have been
switched to the "on" position.
i
If errors occur, they will be displayed on your PC's
monitor. Section 5 describes how you should proceed.
�.�.�

Switching off

i
When you switch off your PC, you must wait at least
30 seconds before switching it on again.
1. Close all running programs.
2. Click "Start >> Shut down".
"
The PC switches off after automatically after Windows
shuts down.
�.�.�

Restart

i
If the PC fails to respond, you can restart it by briefly
pressing the restart button.
i
Restarting will mean you lose all data in main memory.
|
1 689 989 140 2011-08-01
�.5

Inserting a CD/DVD

i
Only insert the DVD-ROM in the DVD drive if you
have clean hands that are free of grease! Do not
write on the DVD and do not place any stickers on it.
The DVD is unable to withstand high temperatures or
direct sunlight.
1. Press the button for opening and closing the drive
drawer.
 The drawer opens automatically.
2. Place the CD/DVD in the middle of the tray, with the
label facing upwards.
3. Close the drive drawer by pressing the button again.
 The drive drawer closes automatically.
"
The CD/DVD drive is now ready. To remove the
CD/DVD, carry out the above steps in the reverse order.
Robert Bosch GmbH