Publicité
Les langues disponibles
Les langues disponibles
Read all the instructions and warnings first before attempting to operate this Jak.
1. Do not operate Jak on inclined surfaces. Jak must be used on level surfaces only. Unanticipated motion will occur
as soon as Jack lifts tire from surface.
2. Do not overload Jak beyond the load rating (680 kgs per unit).
3. Do not start the vehicle's engine, or drive with Jak in use. Jak are designed for hand maneuvering of vehicles only.
4. Do not use Jak to lift tires wider than12 inches.
5. Do not attempt to push Jak over obstacles. They are desjgned to be used on level and reaspnably smooth surfaces
only.
6. After lifting, be sure always lock the pin in place before operating. Pull the pin out after finishing work and then
release the valve.
1. Place Jak on floor and press down on pedal to release pedal lock. Pull out the lock pin from frame.
2. Before operating, open release valve by turning handwheel counter clockwise. Expand Jak by hand- wheel enough
to place around tire and position so both rollers now contact the tire tread. To obtain the best control of Jak while
expanding around tire, place your left hand on top of the left side axle and your right hand at the center of the
pedal. Close release valve by turning handwheel clockwise to a snug- tight position, Jak may now be used.
3. Install Jak so that the unit is parallel to the sidewall of the tire to be Iifted. Leave apporximately 3/4" of clearance
between tire and Jak. This is very important. If unit is misaligned, it is possible that the tire will be forced to hit the
axle of the Jak and not the rollers, this may damage the Jak and void the warranty.
4. To lift tire, flip directional lever up and place foot on pedal depressing with smooth, even storkes. Cycle pedal until
tire is lifted from surface one inch or less. After lifting, the lower the tire is to the ground the more stable Jak will
be. After lifting, be sure always lock the pin in place before operating. Repeat process on the other tires and
maneuver the vehicle as required.
5. To release Jak, pull the pin out from frame and open valve by turning handwheel counterclockwise slowly, Jak may
be removed when rollers disengage from tire.
ENGLISH
WARNING!
OPERATING INSTRUCTIONS
5
Publicité
