Summit FF410WH Guide De L'utilisateur page 10

English
9. Align the pin of the top hinge with top hole on the left side of the
door and push into place. Replace the screws in the upper hinge
bracket but do not tighten all the way. (see fig. # 2)
10. Make sure the door closes easily but forms a tight seal. Adjust the
door as needed. Once you are satisfied with the door alignment,
completely tighten the upper door hinge screws.
11. Replace the hinge cover. (see fig. # 2)
12. If the door does not close properly, refer to the section titled
"Door Alignment".
screw hole plug
NOTE: As the door gets pressed-in during shipping, after reversing
9
lower hinge bracket
the door, the gasket may have to be reset. This is done to
prevent the cool refrigerated air from escaping. If there is a
gap between the door gasket and the cbainet, set the gasket by
gently pulling it out to seal the gap.
door pin
fig. # 3