Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Basic Operation

Turning The Light On
Insert the PowerCon Cable of the external Power Adapter into the PowerCon Connec-
tion Port (19) androtate clockwise to lock in place. Plug the light into an appropriate
outlet. The On/Off Button (20) will lightred to indicate it is in stand-by mode. Press the
On/Off Button (20) to turn on the light. The On/Off Button (20) will light green to
indicate it is in working mode.
• Positioning The Q500
To adjust the Q500, grasp the Handles (11) then loosen the Tilt Lock Lever(10). Adjust
the angle to the desired position then tighten the Tilt LockLever (10) to secure.
• Adjusting Beam Angle
Adjust the beam angle by turning the Focusing Knob (6). The lens tube will extend,
moving back and forth from the lamphead housing.
• Mounting The Q500
The Q500 can be mounted in a standing or hanging position with the Junior Pin
Receiver (7). In order to mount the light, insert the stud of the C-Stand into the Pin
Receiver (7) and secure by tightening the Stand Locking Pin (8). When mounting in a
hanging position, secure the light with a Safety Cable (Not Included).
• DMX Interface
The Q500 is equipped with two DMX interfaces. RJ45 (23) or XLR ports (21 & 17) are
used to send the DMX signal to the lamphead. Both interfaces include in/out ports for
the purpose of daisy-chaining the DMX line through to the next lamphead.
• USB Interface
The Q500 is equipped with a mini USB port for updating the Q500's firmware. Please
register your product at www.fiilex.com to be informed when firmware updates are
available.
3

Publicité

Table des Matières
loading

Table des Matières