If a device is charged with the Powerbank and the Powerbank has almost
reached its capacity limits, this is signalled by flashing of the last status
LED. Please charge the Powerbank again.
Please note that, when charging a device with a Powerbank nearly 30%
of total capacity is consumed by the charging process alone. This is
caused for example by the loss of power from circuit heat and voltage
conversion.
For optimal performance, the Powerbank must be used regularly. If this
is not the case, fully charge the Powerbank at least every three months.
Make sure that the heat caused by the charge process can be discharged
from the device (ideally put Powerbank on a solid and heat-resistant
surface during the use).
Exclusion of liability
Changes to the firmware and / or hardware can be made at any time
without prior notification. For this reason it is possible that parts of the
manual, technical data and images in this documentation may deviate
slightly from the product in your hand. All products described in this manual
are only for the purpose of clarification and must not necessarily match any
certain situation. No claims can be made based on this manual.
Page 8 of 10
EN