Storage; Maintenance; Troubleshooting - WAGNER 725 POWER STEAMER Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STORAGE

Never store the unit with water in the water
tank.
1.
Unplug the steamer from the power source.
2.
Wait a minimum of 2 minutes and slowly open the hose
connection. Drain any remaining water from the water
tank.

MAINTENANCE

Over time, the water tank may experience
i
mineral build-up caused by the high mineral
content found in most local water supplies.
One way to avoid this is use distilled water
with this steamer.
If you are unable to use distilled water, follow
the steps below to remove mineral build-
up. It is recommended that these steps be
performed on a periodic basis.
1.
Follow the Storage instructions, above.
2.
Using a measuring cup, mix 8 ounces of vinegar and 8
ounces of clean water.
3.
Remove the fill cap. Slowly pour the water/vinegar
mixture ino the reservoir.
4.
Allow the unit to sit (unplugged) for at least 30 minutes.
5.
Empty the water tank of the water / vinegar mixture.
6.
Rinse the water tank with fresh water and drain. Repeat
until the vinegar odor dissipates.
7.
Replace the fill cap and store the unit in a cool, dry place.

TROUBLESHOOTING

MALFUNCTION
The steam generator is not working
CAUSE
Heating element covered in limescale
Too little water in tank. A safety cut out is
fitted to prevent overheating of element if
there is little water in tank
Unit at an angle, heating element is not
in water
EN
REMEDY
➞ Clean
➞ Fill with more water. Wait 2 minutes.
Refill will reset the cut-out element
➞ Move unit into horizontal position
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières